 |
The AP013 80mm adhesive mounting disk allows you to mount an Arkon or
third-party 70mm windshield suction mounting pedestal to your car’s
dashboard, including Arkon’s mounting pedestal models GN079WD-SBH,
GN068WD-SBH, GN022-SBH, GN014-SBH, GN015-SBH, and GN042-SBH, CM014, GN014, GN115, TTO115,
TTOXL115, TT115, PTM115, and BBP115 series and other pedestals.
(Note that
the disc is meant to be a bit larger than the mount to ensure a secure
fit.)
This package includes 1 adhesive disk (mounting pedestals
sold separately).
To apply the adhesive disk to the car’s dashboard,
simply remove the paper backing from the back of the plastic 3M dash
mount disc, then place and press down on a previously cleaned surface.
(Use included alcohol pad to ensure mounting area is clean and free of
any dashboard conditioners or other treatments. For best results, allow
24 hours for the disk adhesive to cure on the dashboard before securing
the base of the mount to the center of the disk.) While this disk is
meant to be a semi-permanent solution, the disk can be removed from the
dash by applying a generous amount of rubbing alcohol or similar
adhesive removal product to the area with a cotton swab. Let the liquid
saturate the area, then work a long piece of dental floss under the disk
to cut through the adhesive until the disk is removed.
For a 90mm disk
to use with 80mm suction mounts, see Arkon Model AP020.
View the USER MANUAL for
this product for complete specifications and installation and removal
instructions.
AP013 - 1 pc
|
|
 |